ISD v4.0.3
To experience ISD quickly, you can install it and deploy your applications. The instructions below are intended to get you started quickly and try out ISD functionality.
Note: The instructions below are not suitable for production or any other environment where security is a concern, for production-grade installation of ISD/Spinnaker please refer to ISD 4.0.3 GitOps Installation.
The page helps you to install ISD quickly with the following simple steps.
Pre-requisites
- You should have access to a Kubernetes cluster with at least 2 nodes
- Each node should have a minimum of 32 GB RAM and kubectl set-up.
- 1.Execute the following commands (copy-paste in a terminal window):kubectl -n opsmx-isd apply -f https://raw.githubusercontent.com/OpsMx/isd-quick-install/main/isd403/isd-gitea-quick.yamlWait for 20-30 minutes, depending on your network speed. It is normal for some pods to go into an error/crash loop before stabilizing.
- 2.Execute the following command to check the status of the pods:kubectl -n opsmx-isd get po
- 3.Once all pod displays "Running" or "Completed" status, wait for a few minutes and then execute the following command:
kubectl -n opsmx-isd port-forward svc/oes-ui 8080
## Keep running, it shows messages such as "Forwarding from 127.0.0.1:8080 -> 8080"Wait for about 5 min. The halyard pod might restart during this period. - 4.Now, open your browser, navigate to http://localhost:8080, and login using the credentials listed below:
- User Name: admin
- Password: Execute the following command to retrieve the passwordkubectl -n opsmx-isd get secret isd-openldap -o jsonpath='{.data.LDAP_ADMIN_PASSWORD}'| base64 -dIn case "base64 command not found": Please execute the below command.kubectl -n opsmx-isd get secret isd-openldap -o jsonpath='{.data.LDAP_ADMIN_PASSWORD}'After executing the above command, copy the output and decode it using any online decoding site such as https://www.base64decode.org/.
After login into ISD, please go to "Setup"--> "Integrations" --> and click "Sync CD Accounts" to complete the post-installation setup.

After the successful login, users can create an Application, Pipeline, Integration, Policy, and Agents. To learn more about them, click on the links below.
Last modified 3mo ago